v0.5-beta - Actions system, logging

With this release, we're going from alpha to beta (though it's still a closed beta for now)!

The highlight here is the Actions system, meant to give VTubeStudio users a little more flexibility. In less exciting news, I've also added log files!

Actions

In addition to passing the rumble through to VTS as a parameter, it now also allows you to trigger avatar hotkeys when the rumble value enters and/or leaves a specified range. You can create multiple actions, allowing you to trigger different hotkeys as your health drops or as you take more hits. 

To use the Actions system, connect RUMP to VTubeStudio, and four buttons will appear: Add New Action, Apply Actions, Save Actions, and Load Actions. 

To get started, click Add New Action. Underneath the buttons, a box will appear with three separate sections: "Rumble range", "Trigger when", and a dropdown box. 

To create an action:

1. First, use the dropdown box to select the hotkey you would like to trigger (this is a lot easier to do if you made sure to give the hotkeys names in VTS!).

2. Then, set the rumble range that will activate this action. The "min" and "max" values are the lowest and highest rumble values that should activate this action.

3. Finally, use the Trigger When checkboxes to set the action to trigger when the rumble value enters the set range, leaves the set range, or both. Leave both checked if your action is a toggle (such as an expression) that you want to turn on when it enters the range and turn off when it leaves the range. On the other hand, if your action is a one-time thing such as an animation, you might want to have it trigger only when the rumble first enters the range.

4. If you want to have more actions, click Add New Action again to add another action, and repeat steps 1-3 to set it up. There's no cap on the number of actions you can have.

5. If you want to get rid of an action, hit the X in the upper right corner of the action's box, which will remove it.

6. When you've set up all your actions, click the Apply Actions button, which will activate the actions. This is important! Any changes you make to the actions list will not be applied until you press this button!

7. If you want to save your action setup so you don't have to set it all up from scratch next time, click the Save Actions button, which will allow you to save a copy of your current Action set for later. This will bring up a dialog asking you to type in a saved name, and then let you submit it. If you enter the name of a previously-saved action set, you'll overwrite it (be careful, as it won't ask for confirmation first). If you change your mind and don't want to save, hit the white X in the upper right corner to close the dialog.

8. The Load Actions button brings up a list of saved action sets that are associated with your avatar. Click one to load it.

Note that since hotkeys are avatar-specific, Actions are also avatar-specific. You will only be able to load Action sets that were created with the currently-active avatar, and if you change avatars then any actions you have currently active will need to be redone.

Logging

RUMP now creates log files in the resources/logs directory, allowing for easier debugging for users.